Hammerite Direct to Rust Metal Paint Smooth White 750ml
$45.62

(Incl. GST)

  • Free Shipping Throughout NZ

  • 1 - 3 Business Day Shipping

  • 30 Day Free Returns 

  • Proudly New Zealand Owned & Operated

Product Description

Brand: Hammerite

Hammerite Smooth 750ml White

Smooth White 750ml

Paint directly onto rusty surface without the need for a primer or undercoat

Fast dry and recoat times means the job can usually be done in a day

8 Years Protection

Hammered, smooth & satin finishes

About Hammerite Smooth range

Durable, corrosion resistant decorative coating for ferrous and non-ferrous metals, certain plastics and wood. This is a brilliant gloss finish which will retain its sheen for years.

. • Can be applied directly onto rusty metal. .

• No need for primer or undercoat. .

• Corrosion resistant. .

• Hammerite forms a superior barrier that not only seals out moisture but gives long lasting protection both inside and outside. .

Preparation

1. Abrade smooth surfaces and remove all loose rust and flaking paint with a wire brush. .

2. Remove dirt, dust and grease with diluted detergent. Rinse with clean water and allow time to dry. .

3. Paint a test patch of Hammerite Direct to Rust Metal Paint Smooth onto painted surfaces and leave for 1 hour. If there is no reaction apply Hammerite Direct to Rust Metal Paint Smooth directly to surface. .

4. If there is a reaction, remove all paint before applying Hammerite Direct to Rust Metal Paint Smooth. .

5. On bare zinc, aluminium and galvanised surfaces apply Hammerite Special Metals Primer before applying Hammerite Direct to Rust Metal Paint Smooth. .

Application

1. Ideal application temperature 8-25degC.

2. Lightly stir before use. Do not mix vigorously. .

3. Do not mix paint from 2 tins or mix colours. .

4. Brush application: Do not thin. On previously painted metal in sound condition, 1 coat should be sufficient. On bare/rusty metal 2 coats are required. Ensure that all edges and corners are adequately covered. Do not over-apply as sagging will occur. .

5. Coventional spray application: Thin with Hammerite Brush Cleaner & Thinners at a ratio of 15% Thinners to Paint. Set spray gun at 25/35psi and use full fan spray at maximum volume. Apply 4 thin coats. Allow 1 hour between coats. Refer to spray equipment manufacturer’s guidelines for the correct and safe use of sprayers. .

Coverage: 5 square meters per litre

Durability: 8 Year Protection

Repaintable after 4 hours

sku: PAIS-075W

Related Products

Tool Factory Testimonials

Looked for a couple of sockets everywhere but couldn't find them until I found you guys. Thanks for the quick delivery too. A+


Kyle M

19-12-2018

Tauranga

Hi, Received the two 20 ton squat jacks I ordered off you guys today. Just wanted to say thank you. Extremely prompt and efficient service. Would recommend your company highly. Thank you again


Jon

12-07-2018

Christchurch

Super easy ordering & quick delivery. Will look to use you guys again. Thank you. A++


William

01-06-2018

Wellington